nachdem mir die Suchfunktion keine ausreichende Antwort gegeben hat, versuch ich´s hier:
Ich hab lt. Sisoft folgende Hardware:
Device Information
Device Type : SCSI Mass Storage Controller
Device ID : bus 1, device 9, function 0
Windows Device Name : Adaptec AHA-294X/AIC-78XX-PCI-SCSI-Controller
OEM Device Name : Adaptec Inc AHA-2940/W Fast/Wide SCSI Host Adapter
OEM Hardware ID : FUN_0, VEN_9004, DEV_7178, REV_03
Revision / Stepping : A / 4 (3)
Device Capabilities
Line Cache Size : 8 bytes
Latency Timer : 32 clocks
I/O Access : Yes
Memory Access : Yes
Bus Master Capable : Yes
Special Cycle Recognition : No
Memory Write & Invalidate : No
VGA Palette Snoop : No
Parity Error Response : No
Address/Data Stepping : No
System Error Line : No
Fast back-to-back Transactions : No
Detects Parity Errors : No
Supports System Error Line : No
Supports Parity Line : No
User Defined Format : No
PCI 66MHz Bus Support : No
New Capability List : No
Device Select Timing : Medium
Multi-Function Device : No
Header Type : 00
Programming Interface : 00
Hardware Resources
I/O Port : 0000D800
Memory Address : E7000000
IRQ Line : 17
INT Pin : A#
Dynamic Management : Yes
da hängt folgender Streamer drauf:
General Information
Device Type : Sequential Access (Tape)
Manufacturer : SONY
Product Name : SDT-9000
Version : 0601
Serial Number : 7Ê(¬
Removable Device : Yes
Embedded Media Changer : No
SCSI General Properties
Target ID : 1
Logical Unit Number : 0
ANSI SCSI Approved Version : SCSI-2
Device Currently Connected : Yes
Bus Width : 8-bit
Addressing : 8-bit
Multi-Ported Device : No
Relative Addressing Mode : No
Synchronous Transfers : Yes
Data Transfer on Secondary Bus : No
Asynchronous Event Notification : No
Command Queuing : No
Linked Commands : No
Soft Reset : No
Normal ACA : No
Terminate I/O : No
Meine Frage:
kann ich da diese Platte dazuhängen? oder wie läuft das bei SCSI?
http://shop.birg.at/shop/artikeldet...artikelnr=07970tia
neo
Anmeldung