URL: https://www.overclockers.at/mainboards/dfi_lanparty_nf3_s939_agp_142949/page_1 - zur Vollversion wechseln!
wow
endlich ein S939 DFI brettl mit AGP *freu* vl. leg i ma des zu. damit wird wohl DFI MSI vom oc'ing thron stürtzen.
[QUOTE] Lanparty UT nF3 Ultra-D
Chipset: nVidia nF3 Ultra AGPset
CPU : Socket-939 for AMD Athlon64 and Athlon64 FX51 to FX55+ processors
FSB: 2000MTps Hyper Transport
Memory:
128-bit Dual-channel memory architecture
4 184-pin DIMM sockets 4GB in max.
Supports unbuffered, single/double-side DDR-266/333/400 DIMMs
Supports x8/x16, non-ECC/ECC and up to 512Mb DDR devices
Expansion Slots:
1 AGP-8X/4X (0.8/1.5v only)
5 x PCIs
Storage:
1 Floppy port
2 parallel IDE ports with up to 133Mbps UltraDMA
4 serial ATA ports with up to 1.5Gbps (2 native; 2 via Marvell 88SR3020 S-ATA PHY)
Support nVRAID-0/1/0+1/JBOD across P-ATA and S-ATA
USB: 8 USB2.0 ports (4 at rear, 4 on board)
Audio: Realtek ALC655 6CH audio CODEC
LAN: VITSSE VSC8201RX GbE PHY
IEEE 1394: VT6307 with 2 IEEE1394 ports
Legacy I/O: IT8712F
Hardware Monitoring:
CPU/System temperature sensing w/ overheating alarm
CPU overheating protection during system boot-up
12v/5v/3.3v/Vcore/Vbat/5Vsb/Vnb/Vdimm/Vagp voltages sensing
CPU/System fan speed sensing
Back panel I/O ports:
1 x PS2 mouse, 1 x PS2 keyboard, 1 x Printer
1 x S/PDIF-In, 1 x S/PDIF-Out, 1 x COM,
2 USB2.0 ports, 1 x IEEE-1394
2 USB2.0 ports, 1 x RJ45
3 audio jacks for 6CH audio outputs
Other onboard connectors:
2x USB header for 4 USB2.0 ports
1x header for IEEEE-1394 port
1x IRDA header
3x 3-pin FAN connectors for CPU, Chipset, and Chassis
1x SPDIF-In/Out header for Optical module upgrade
1x CD-In header with housing
Front audio select header
Piezo-buzzer
Clear CMOS data header
Standby/S3 LEDs
Front panel headers (IDE LED, Power LED, Power switch, Reset button, PC speaker)
l 20-pin ATX & 4-pin ATX power connectors
Form Factor and PCB Size l ATX, 305x240mm
BIOS features l 4Mb flash ROM;
l ACPI; PnP; Hotkey flash; Wake on Ring/LAN/USB/Keyboard and Mouse;
Manageability l DMI 2.0, WOL by PME; WOR by PME; PXE2 Boot
Excellent Over-clocking
Capability
Voltage tuning:
Vdimm (up to 3.2v)
Vagp (up to1.8v)
Vcore (up to 2.2v)
Vnb (up to 1.95v)
1MHz frequency subtle tuning for FSB
Adjustable CPU Multiplier
Aync. PCI/AGP mode
EMI Regulations l FCC Class B, CE
Certifications l AMD; XP WHQL
Accessories:
Users Manual, CMOS Reoloaded Manual
2x Parallel IDE yellow round cable
1x FDD yellow round cable
2x Serial IDE cables with S-ATA power cable
Driver CD
1 Floppy diskette for nV RAID
I/O shield
Features Dual storage controllers deliver unmatched multi-disk performance
GbE LAN
NVIDIA nTune Utility:
- Voltage, Bus frequency, Fan speed, temperature monitoring
- Voltage, Bus frequency, Fan speed, temperature On-the-fly tuning for over-clocking
- Performance auto tuning
- GPU overclock
nV RAID software for both S-ATA and P-ATA
NVIDIA Personal Firewall [/QUOTE]
Quelle: http://www.hardwareasylum.com/forum...thread.php?t=64
Alda, Alda, das finde ich w00t endlich bringt DFI auch ein S939 brettl für AGP, aber leider erst jetzt.....
ich gehe auch mal stark davon aus, das das DFI der neue OC thronhalter auf NF3 sein wird...
vielleicht gehen, die meisten venice cpu in nächster zukunft so gut wie sich alle erhofft haben, dann kauf ich mir das brettl vielleicht auch, weil graka werd ich so schnell mal nicht tauschen.
super aktion von DFI, nur wie schon gesagt, leider spät!
greetinx NeseN
Ich freu mich schon, werds mir denk ich anschaffn statt dem Gigabyte Teil :|
warum nur 3.2V Vdimm, muss ich mir doch das NF4 holen und eine PCIE Grafikkarte, ist schon etwas wenig *g*
vl. gibts ja so ein tictac bios wie beim nf3 S754... oder vl. gibs auch jumper für 4V... lang kanns ja nimma dauern bis es jmd. hat
Bzw. was mir fehlt fürs überboard, is n 2tes ma LanOnboard
tja, stimmt.... etwas spät!
naja, evtl bleib ich jez (noch) bei AGP.... mal schaun
auch wenns in den specs nicht drin steht, dem bild nach zu schließen ist da schon ein 2.gbit chip drauf (marvell).
was z´te ihr wird das teil kosten?
Zitat von rastullahwas z´te ihr wird das teil kosten?
@Victor: woher hast du die ganzen informationen?
In dem Forum dort steht das der Typ DFI angeschrieben hat...
@prob: g0t quelle ^^
das board ist mein
wann kommts raus??
fx freak neeeeee das is meines
der beweis agp lebt juhuuuuu aber 3.2vdimm is mager für meine bh-5..
overclockers.at v4.thecommunity
© all rights reserved by overclockers.at 2000-2025